Skip to content
Dosage guide · 10 mg vial

Epithalon Dosage Protocol

Epitalon · AEDG synthetic pineal tetrapeptide

The reference protocol uses 5 mg once daily for 20 consecutive days, with no step-up. With 2 mL of bacteriostatic water, a 10 mg vial is 5 mg/mL, so 5 mg is 100 units (1 mL) on a U-100 syringe.

How oftenOnce daily
Starting dose5 mg
Start = units100 units
Mix2 mL BAC water

Reviewed 25 Oct 2026 · Education only, not medical advice

Peak Peptides Australia Epithalon 10 mg vial

Epithalon 10 mg vial

View on Peak Also at Pure Performance

Exact Peak Peptides Australia product photo

01 · DOSAGE CHART

Epithalon dosage chart

20-day daily approach · 10 mg vial + 2 mL BAC water

BAC water added
Concentration5 mg/mL
1 unit (U-100)50 mcg= 0.01 mL
How oftenOnce dailySubcutaneous injection

2 mL is the mix shown by Peak, Pure and the reference protocol, so 5 mg is 100 U-100 units.

Epithalon dosage chart for a 10 mg vial mixed with 2 mL of bacteriostatic water
DaysDaily doseSyringe units
Days 1–20Start5 mg100 units1 mL

Once daily · evening or bedtime · subcutaneous injection

The reference protocol specifies 5 mg once daily for 20 consecutive days; there is no dose increase in this schedule.

After the 20-day course, the reference protocol states a 4–6 month break before another course; the break is not a dosing row.

Evening or bedtime is the timing used by the reference protocol.

Reference-site amounts only — Epithalon has no clinically established subcutaneous dose and is not approved as a medicine in Australia. Education only, not medical advice. Dose amounts adapted from Epitalon Epithalon 10 mg vial dosage protocol (PeptideDosages.com); units are recalculated for the vial and mix selected above.

02 · HOW TO MIX

Mixing a 10 mg vial with 2 mL of BAC water

Using a 1 mL (100-unit) insulin syringe, 2 full draws of bacteriostatic water gives 5 mg/mL.

  1. Bacteriostatic water running slowly down the inside wall of a peptide vial1

    Add the water slowly

    Wipe both rubber stoppers with an alcohol swab and let them dry. Draw 2 mL of bacteriostatic water and let it run slowly down the inside of the vial wall — not straight onto the powder.

  2. Hand gently swirling an upright vial in a small circle2

    Swirl gently

    Swirl or roll the vial gently until the powder has dissolved. Give it a few minutes to settle if needed.

  3. A vial being shaken with a red cross through it3

    Don't shake it

    Shaking can damage the peptide and cause foaming. Gentle swirling only.

  4. Close-up of a vial with small undissolved particles and a caution symbol4

    Check it's fully clear

    Only use it once it is fully clear with no particles. Label the vial with the date and 5 mg/mL, then store it in the fridge at 2–8 °C.

Full illustrated reconstitution guide
03 · SUPPLIES NEEDED

What you'll need

Counts follow the dosage chart above at the highest amount in each step, using a 10 mg vial mixed with 2 mL.

Length of protocol
4Epithalon 10 mg vials35 mg needed in total
111 mL insulin syringesU-100, 27–31G · one per draw + one per vial mixed
1BAC water 10 mL bottle8 mL used for mixing
22Alcohol swabsSkin + stopper, every time

Plus an approved sharps container. Syringes and swabs are sold by Australian pharmacies — Peak Peptides and Pure Performance supply the bacteriostatic water.

04 · CALCULATOR

Check a different amount

Enter your vial, water and dose to see the matching syringe units.

Concentration Calculator
mg
2 mL
mg

Concentration

5.00 mg/mL

(5000 mcg/mL)

Calculated Liquid Volume

1.000 mL

Equivalent U-100 volume scale position

100markings (not biological IU)
0102030405060708090100100 marks

Illustration of a U-100 volume scale, not preparation or injection guidance

05 · PROTOCOL DETAILS

About Epithalon

Protocol overview

Starting dose
5 mg once daily
How it increases
No increase in the 20-day reference schedule
Frequency
Once daily for 20 consecutive days
When to take it
Evening or bedtime in the reference protocol
Course and break
20 days, then 4–6 months off in the reference protocol
Common mix
2 mL bacteriostatic water → 5 mg/mL

Storage

Before mixing
Keep the sealed lyophilised vial dry, protected from light, at 2–8 °C or at −20 °C for long-term storage.
After mixing
Keep upright, dark and refrigerated at 2–8 °C; Peak's guide states within about 4 weeks with bacteriostatic water.
Never
Do not freeze a mixed vial or repeatedly freeze and thaw it.

How it works

Epithalon, also called Epitalon, is the synthetic four-amino-acid peptide Ala-Glu-Asp-Gly, abbreviated AEDG. It was developed from research into epithalamin, a bovine pineal-gland peptide preparation.

In cultured human fetal fibroblasts, Epithalon induced expression of the telomerase catalytic subunit, telomerase activity and telomere elongation. These are cell-culture findings, not proof of a health or longevity effect in people.

In senescent female rhesus monkeys, investigators reported increased evening melatonin synthesis and normalisation of cortisol rhythm. Animal findings do not establish a human outcome.

Illustrated mechanism explainer

What the research shows

  • A 2003 cell-culture paper reported telomerase activation and telomere elongation after Epithalon was added to telomerase-negative human fetal fibroblasts; it was not a human dosing trial.
  • A 2025 cell-line study reported dose-dependent telomere-length extension in normal epithelial and fibroblast cells, while breast-cancer cell lines showed alternative lengthening of telomeres activity. This was laboratory work, not clinical evidence.
  • In a mouse experiment with 54 animals in each group, Epitalon did not change mean lifespan; it increased the lifespan of the last 10% of survivors by 13.3% and maximum lifespan by 12.3%. Animal findings cannot predict human benefit.
  • A 12-year randomised clinical study reported 28% fewer deaths with epithalamin, a pineal-gland peptide preparation rather than synthetic Epithalon. It does not establish the dose, benefits or safety of this product.
  • ClinicalTrials.gov lists one enrolling-by-invitation early phase 1 study with estimated enrolment of 48 that includes topical Epitalon peptide serum at about 1–3 mg/mL; no results are posted and it does not test this subcutaneous schedule.
  • The ARTG returned no matches for Epithalon or Epitalon. FDA's orphan-drug record lists an Epitalon designation dated 2010 as withdrawn or revoked and not FDA approved for the orphan indication.

Reported side effects

  • There is no completed clinical safety dataset for 5 mg subcutaneous Epithalon once daily; the current ClinicalTrials.gov record has no results posted.
  • A 2025 review concluded that critical short- and long-term toxicity information, including genotoxicity, carcinogenic potential and drug-interaction data, remains missing for Epitalon.
  • The review describes a historical retinal report in 162 people using 5 mcg per eye for 10 days with no reported side effects. That route and microgram amount are not comparable with this 5 mg subcutaneous reference schedule.

Important notes

  • Epithalon is not an approved medicine in Australia: ARTG searches for both Epithalon and Epitalon returned no matches.
  • For tested athletes, WADA's 2026 S0 class prohibits any pharmacological substance with no current approval by a governmental health authority. Epithalon is not named explicitly in the list, but its unapproved status means this category appears to apply.
  • The calculator uses the nominal 10 mg vial strength. Peak's posted LabDoc for one tested batch records 9.34 mg measured content, so check the current vial label and batch documentation rather than assuming every vial matches the nominal amount.
  • Human safety data do not establish the safety of this schedule, including its long-term effects or cancer-related risks.
  • Never use a mixed vial that is cloudy or has particles in it.

Injection basics

  • Use a new sterile 1 mL (100-unit) U-100 insulin syringe, 27–31G, every time — never reuse or share.
  • Wipe the vial stopper and the skin with an alcohol swab and let both dry first.
  • Inject under the skin (subcutaneously) of the abdomen, thigh or upper arm, and rotate sites.
  • Put used syringes straight into an approved sharps container — the NDSS lists Australian disposal options.

Guidance: World Health Organization · National Diabetes Services Scheme (NDSS)

06 · QUICK ANSWERS

Epithalon questions

How many units is 5 mg of Epithalon?

With 2 mL in a 10 mg vial, the concentration is 5 mg/mL. A 5 mg amount is 100 units, which is 1 mL, on a U-100 syringe.

How much bacteriostatic water for Epithalon 10 mg?

The default mix is 2 mL of bacteriostatic water in a 10 mg vial. That gives 5 mg/mL, where 20 U-100 units equals 1 mg and 0.2 mL.

How long does a 10 mg Epithalon vial last?

At 5 mg once daily, a nominal 10 mg vial lasts 2 days. A 20-day course at that amount requires 10 nominal 10 mg vials.

What is 1 mg of Epithalon in a 2 mL mix?

With 2 mL in a 10 mg vial, 1 mg is 20 U-100 units, or 0.2 mL.

07 · SOURCES

References

Related dosage guides

All dosages